 |
 |
Much like the
Extended Collet Chuck, the Weldon Shank Extended Adapter has a Weldon Shank bore used for tight spaces or
additional reach. The Weldon Shank Extended Adapter allows access into narrow holes by reaching farther from
the face of the tool holder. This keeps the process on your turning center without finding an entirely new tool
holder. These narrow or small restrictions can lead to costly solutions when retooling for this type of job.
Additionally, the tool holder that was too short for the job can be kept in the turret. Instead of
replacing an entire tool to accommodate the reach, all you need to do is install an extended adapter. Placement
of a new adapter in the collet pocket transforms a useless tool holder into a working tool holder with a
Weldon Shank Extended Adapter connection. Each adapter is equipped with a set screw at the bottom of the
chuck to act as an adjustable stop.
<
Back
|
